AP 3702i - IOS version for Autonomous Mode

[roxanateodosiu]

Hello community,

Could you tell me what version of IOS do I have to use for an AP 3702i in order to configure it in Autonomous Mode (and not only in Site Survey).

The current installed version of the IOS is 15.3(3)JBB. (ap3g2-k9w7-xx.153-3.jbb)

On this site http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15_2_4_JB/configuration/guide/scg15-2-4-Book/scg15-2-4-preface.html I found that the previous version 15.2(4)JBa allows only the Site Survey mode for the 3700 APs. Is it still the case for the 15.3(3)JBB version?

Thanks!

Roxana

[Leo Laohoo]

Any autonomous IOS can be used for site survey.

[roxanateodosiu]

Thank you for you reply, but I am looking for Autonomous Mode IOS which don't support only the Site Survey mode.

[marc.groenen]

You can use ap3g2-k9w7-tar.153-3.JBB1.tar

k9w7 means its used for autonomous mode k9w8 means its used for lightweight mode.

When the k9w7 image is loaded you can configure the autonomous AP for any purpose ie. Sitesurvey

[roxanateodosiu]

Thank you for you reply.

I'll try and let you know.

[Venkatesh Attuluri · Accepted solution]

use 15.3.3-JBB1, File Name:ap3g2-k9w7-tar.153-3.JBB1.tar

you can download it form here

http://www.cisco.com/c/en/us/support/wireless/aironet-3700i-access-point/model.html#~tab-downloads

and for more information check release notes of this version here

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ios/release/notes/rn-15-3-3-JBB1.html