06-20-2019 12:25 AM - edited 07-05-2021 10:35 AM
Dear,
Could someone please check and verify of this is normal.
When I export the config from the GUI or CLI, I don't see the which AP are listed under which Flexconnect group.
I need to have this information to automatically update the config on the N + 1 redundancy controller.
Now I have to visually check every Flexconnect group and then copy past the mac of the AP to the other controller…. ☹
Kr
Niels
Solved! Go to Solution.
06-25-2019 03:57 AM - edited 06-25-2019 03:59 AM
Hi
WC01) >show run-config commands
...
flexconnect group 00027A add flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A radius ap server-key <hidden> ...
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.152.0
Can see the AP MAC in flexconnect config.
06-20-2019 05:38 AM
What command did you use to show the running config in CLI?
Try:
***for the full running config***
show run-config commands
***for flexconnect config***
grep include "flexconnect group" 'show run-config commands'
***Please mark this as an acceptable solution if it helped. Thanks.***
06-25-2019 01:12 AM
06-25-2019 03:57 AM - edited 06-25-2019 03:59 AM
Hi
WC01) >show run-config commands
...
flexconnect group 00027A add flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A ap add 34:db:fd:xx:xx:xx flexconnect group 00027A radius ap server-key <hidden> ...
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.152.0
Can see the AP MAC in flexconnect config.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: