I'm using a WLC 5508 and light weight 1142 AP's with software version 7.0.116
I wonder why there is no cli-clear or cli-reload command if I am connected via SSH/telnet to an access point. When I connect through console port there are this commands available. Is this a configuration issue?
Any ideas? Thanks in advance.
I was able to ssh to my 1142 and do a clear and reload command. Did you make sure you are in enable mode? I'm running 220.127.116.11, but I don't think that matters.
Yes, i've been in enable mode. i will try the new software image.
Sent from Cisco Technical Support iPad App
shame on me
I've worked with the default login and password. After changing it in global config dialog at my WLC, I can see much more commands at the cli prompt.