09-27-2013 07:57 AM - edited 07-04-2021 12:57 AM
Hi
I bought a new 1602E ap .. so it comes with no documentation and the only doc that i foudn in the net it was this:
http://www.sws.cz/prod_img/cisco/ap1600getstart.pdf
but I need the started guide to the basic configuration ..
My concern is because the AP will be used for a producction enviroment and the point will be
what will be the best radio configuration with open with non security .. ? 2.4 or 5ghz ..
is any one know about it I appretitate your support
thnks in advanced
regards
Solved! Go to Solution.
09-27-2013 11:21 AM
Hi,
do you have AIR-CAP or AIR-SAP
as AIR-CAP is controller based AP where you need the WLC to get the AP configured. Simply you have to connect the AP with POE.
AIR-SAP is standalone and below is the doc to configure it:-
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c0b93c.shtml
2.4 GHZ or 5GHZ depends on what type of clients you want to connect ? If you have clients with A radio/ N radio then you need 5 GHZ and if your client is having G radio/N radio you can go for 2.4 GHZ.
09-27-2013 11:21 AM
Hi,
do you have AIR-CAP or AIR-SAP
as AIR-CAP is controller based AP where you need the WLC to get the AP configured. Simply you have to connect the AP with POE.
AIR-SAP is standalone and below is the doc to configure it:-
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c0b93c.shtml
2.4 GHZ or 5GHZ depends on what type of clients you want to connect ? If you have clients with A radio/ N radio then you need 5 GHZ and if your client is having G radio/N radio you can go for 2.4 GHZ.
09-27-2013 11:39 AM
thanks it is
AIR-SAP
I will chek the documents .. thnks //
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: