i have one issue regarding the backup port i already have a cisco 3504 and i configured the manegement VLAN to use port number one and i made the backup port as port number 2 in physical information
port number 1
backup port 2
active port 1
enable daynamicAP management enable
however when i disconnect the cable connected to port 1 the second one became enabled like expected, i can ping it by i couldn't mange the device from the web management IP however i could do this before from the port one when it was up .
It should work, I usually go back and https:// and remove the rest as at times my browser hangs. Many prefer to just use LAG and have an etherchannel which works the best. Using primary and backup is usually a work around if a switch doesn’t support etherchannel or you are swinging one port to the dmz for example.
IntroductionFeatured ExpertQ: Does switch port support uplink the mac-sec link?Q: Will the older 16.10/16.12 IOS XE SD-WAN (stand-alone) images be maintained for a specific amount of time going forward? Will these stand-alone code branches receive mainten...
This is a two-step process.
Step 1: Need to add the FlexConnect AP to a FlexConnect Group.Step 2: Need to configure a FlexConnect ACL (to specify the local traffic-of-interest), and map it to that FlexConnect Group.
For step 1----------As in the i...
Hello , We faced issues with Cisco AnyConnect when trying to connect at home network. we have 2 scenarioScenario 1: one home network and Cisco AnyConnect gives "limited or no connectivity" error messageScenario 2: multiple networks and Cisco An...
Hello, We're running WLC 9800-40 with version 16.12.2t with SFP-10G-LR-S. I have some questions regarding SFP-10G-LR-S:1. Is this model supported by Cisco? If not Which model do you recommend for WLC9800-40?2. Would SFP-10G-LR-S cause issues with upg...
Hello, I just received my new 240ac access point!I tried to configure it twice now but each time I set the IP to be static I can wait more than an hour and it is still flashing 3 colors. Last time I lost my patience and after 30min I reset...