We are operating our vehicles remotely in the underground mines over Wi-Fi, the data load from the machine is constant around 30Mbit/s (yes, six to eight HD-cameras).When switching between APs we have noticed that we sometimes get a transmission gap ...
Forum Posts
Hello. The following alarm is constantly occurring in the C9800-CL raised to vm. It's like an alarm related to a license, is there a solution? -----------------------------------------------------------------------------------------------------------...
Wired guests are not able to get out to internet, they can ping only at when payload is set to 1300 bytes or lower, this seems like an MTU issue, but its only effecting wired guest not wireless guest. Setup is a 9800 foreign on 17.9.5 code and 5520 a...
l installed newest version of Wireless controller 9800-CL Cloud but wont Join DTLS Error l dont why it wont join to controller
We have a 9800-CL Wireless Controller running 17.12.2. We just got a new CW9164I-ROW AP and its registered by the operational interfaces are down due to a regulatory domain error. Is there a way to change the regulatory domain for the access point?...
Hello everyone,I'm trying to figure out a frustrating issue. Attempting an install of APSP6 keeps bombing out and I'm unsure what steps to take next. Software: Version 17.09.04aROM: 17.3(3r)Error in question: Dec 13 21:21:01 Eastern: %INSTALL-3-OPER...
Hey everyone,Questions - on a guest WLAN I have client isolation enabled via the Peer to Peer blocking action to drop. I can see it blocks peer to peer unicast traffic, however multicast traffic between peers still flows. I can limit the mdns messa...
Resolved! How to disable mac address in 9800 WLC
Hi Guys, As we know, there is option in Cisco 5520 WLC to mannualy disable any Mac addresses of user to deny network access to him. Is there any disable mac address option in Cisco 9800 WLC?
I'm trying to find a trustworthy source about the assignment algorithm of wireless traffic when many wireless clients send traffic to WLAN associated with an interface group, let's say with 4 VLANs. the documentation below doesn't say anything about ...
Hi I got a pair of 5520 in SSO mode version 8.10.190. If you want to run OEAP then you need to enable Enable NAT Address on the management interface. The problem is that the "Enable NAT Address" is greyed out: the question is: is it possible to enab...
I'm trying to get environmental stats back from 9136/9166 on Spaces. I've imported the maps successfully and have enabled the IOT service in spaces. I'm still getting errors for the TDL Telemetry under the troubleshooting section which seems to be pr...
Hello,I've got question related to this particular debug entries (from radioactive trace):2024/04/18 13:06:43.944436 {rogued_R0-0}{1}: [rogue-capwap] [25943]: (debug): Client info (2/2), MAC:<xxxxxx>, reported by yyyyyyy, GW: 111111111, chan:40, rssi...
Dear All.,My Cisco WLAN CONTROLLER 2504 suddenly started to De-associate Access Points. Attached herewith is the Error Message gotten from the GUI Let me know if anyone has solution to address this thanks.
Resolved! 9800 Guest Anchor Design
I am trying to understand Guest Anchoring with the 9800 Controllers. In the 5500 series WLCs you had to access the WMI from the inside network through the firewall to the Anchor Controller Mgmt Vlan on a DMZ. Then create another sub-interface on the...
