cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1350
Views
0
Helpful
7
Replies
Highlighted
Cisco Employee

Capwap 1142 to Autonomous

I have an 1142 running capwap c1140-k9w8-tar.124-23c.JA4  that I am wanting to convert to an Autonomous AP.

However, the AP does not seem to have an archive exec  command to tftp downoad an new IOS.

Is there another procedure that should be used?

Thanks

John

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Did you go into the config mode?

AP#en

AP#config t

AP#debug capwap console cli

-Scott
*** Please rate helpful posts ***

View solution in original post

7 REPLIES 7
Highlighted
Cisco Employee

Please use the below link..

https://supportforums.cisco.com/docs/DOC-14960

Regards

Surendra

Regards
Surendra BG
Highlighted

Thanks,

The issue that I seem to be having is that when in enable mode, I do not see an archive command available in the exec.

as is suggested from the doc above.

is it possible that 12-4-23c.JA4 would have a different command structure?

THx,

John

Highlighted

Did you go into the config mode?

AP#en

AP#config t

AP#debug capwap console cli

-Scott
*** Please rate helpful posts ***

View solution in original post

Highlighted

Interestingly,

The AP does not have config t as a command. ( yes, I am in enable mode)

I can issue a debug capwap from the exec, but console is not an option.

Highlighted

Wait... Do the debug capwap console CLI first then try the archive command

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Highlighted

Thank you for the hint!  Doing debug capwap console CLI first did the trick.

Highlighted

Glad you got it working!

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Content for Community-Ad