cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
880
Views
0
Helpful
1
Replies

Change Boot up 2602e

dllaulen20
Level 1
Level 1

Hello everyone

I have an AP 2602e the boot up is:

  1. Find image for Ethernet (3 times)
  2. Find image for DotRadio0 or DotRadio1(for this Interface the AP will find the image (WLC) )


The AP 2602e is managed by WLC 5508 and it´s configured with mesh.

I want change the boot up, the AP takes too long to find the image.


Regards.

1 Reply 1

keglass
Level 7
Level 7

David,

I recommend you also post this to the Cisco Support Community for additional information and feedback.

https://supportforums.cisco.com/

If you think you are experiencing a bug, then please open a ticket with Cisco Technical Assistance Center (www.cisco.com/go/support), where they can help you investigate the issue and can offer expert debugging assistance.

I hope this helps.

Kelli Glass

Moderator for Cisco Customer Communities

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: