cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
49
Views
0
Helpful
0
Replies
Highlighted
Beginner

Changing 2 remote 5508s to HA pair

I have 2 5508 controllers that were originally used as standalone controllers.  The APs have been moved to another controller and I want to set them up as an HA pair for a different group of APs.   The service port isn't connected.   Can I configure these as a pair remotely?    Their mgmt. interface IPs are obviously different and I can't change either of them without causing an conflict. The HA ports are cabled.  If I configure the redundancy management IPs and peers, configure one of the units as secondary will the fact that the mgmt. IP addresses are different cause a problem when I config maintenance mode sso?   Or will they reboot and the secondary will assume the mgmt. IP of the primary?

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards