We have a 2100 controller with 4 wireless AP's, only one connected directly to the controller. I want to use the controller for the DHCP server for Guest, thermostats, in house wireless networks on this system. I cannot seem to get the DHCP setup properly to assign an address according to the SSID they sign into.
Hi, My name is Eric Moyers. I am a Network Support Engineer in the Cisco Small Business Support Center. Thank you for using the Cisco Community Post Forums.
You have posted your question in the Small Business Section. I think that you would get a better response by asking your question here: https://supportforums.cisco.com/community/netpro/wireless-mobility/begin-wireless
None of the Small Business Access Points use wireless controllers, so we can not adequately answer your question.
Cisco Network Support Engineer
Per your suggestion, I have moved the discussion into the Getting Started with Wireless area for Gary so he doesn't need to repost.
Cisco Small Business Community Manager
for Cisco Small Business Products
On the WLC you will want to click on the CONTROLLER and then select the wired side interface your WLAN is mapped to. On the bottom you will see a section for DHCP Server.
What do you have in that field?