cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

635
Views
0
Helpful
7
Replies
Beginner

Cisco 2504 Configuration

Hello,

I have a cisco 2504 controller with 10 AP's. I have 3 WLANs. I would like to have one WLAN only broadcast to 2 of my 10 AP's? Is this possible? If so how would I configure the WLan?

2 ACCEPTED SOLUTIONS

Accepted Solutions
Beginner

Cisco 2504 Configuration

On a 2504 you can't remove a WLAN from the default group, thats why you have to create two groups.

View solution in original post

Highlighted
Beginner

Cisco 2504 Configuration

Yes, no ap's in the default group

View solution in original post

7 REPLIES 7
Enthusiast

Cisco 2504 Configuration

Yep, you can do this with AP-Groups. Create an AP Group and put the right WLANs with the right LAPs.

This will allow you to control what AP's transmit which WLANs.


--
CCNP, CCIP, CCDP, CCNA: Security/Wireless
Blog: http://ccie-or-null.net/

-- CCNP, CCIP, CCDP, CCNA: Security/Wireless Blog: http://ccie-or-null.net/
Beginner

Cisco 2504 Configuration

so i followed the configuration sheet that was listed in the article below

http://www.cisco.com/en/US/docs/wireless/controller/7.0MR1/configuration/guide/cg_wlan.html#wp1128591

Underneath the

Creating Access Point Groups

i followed it and made the modifications. But i am still able to see the one WLAN under all AP's?

Hall of Fame Master

Re: Cisco 2504 Configuration

You need to create two ap groups. One ap group will only have that one SSID and you add that access point to that group and then create another ap group that has all your SSIDs except that one in the other group. Then put all your other AP's in that group. The default group will have all SSIDs created on the WLC... Well WLAN ID 1-16. That's why you need two groups.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Beginner

Re: Cisco 2504 Configuration

Ok i did that but i think i see the problem. underneath the default-group it still has my WLAN listed. Should i remove the WLAN from the default-group? If so how? When i click the drop down arrow and the remove option is looks like it is deleting the WLAN and not removing it from the access-group.

Beginner

Cisco 2504 Configuration

On a 2504 you can't remove a WLAN from the default group, thats why you have to create two groups.

View solution in original post

Beginner

Cisco 2504 Configuration

so the extra AP's that are listed underneath the default-group i have to move to a second AP group?

Highlighted
Beginner

Cisco 2504 Configuration

Yes, no ap's in the default group

View solution in original post

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards