02-25-2020 09:46 AM - edited 07-05-2021 11:46 AM
We have a 2802I AP that is showing as connected on the switchport. It was only pulling 15400 watts. I manually set the power consumption to 26000 watts and then restarted the port. I then reverted back to power inline auto and now it pulls the correct power.
Gi2/0/40 auto on 26.1 AIR-AP2802I-B-K9 4 30.0
Gi2/0/40 XXX-WH-AP10 connected trunk a-full a-1000 10/100/1000BaseTX
The radios on the AP will not come up. Admin is up, but operational is down. I am able to ping the device.
Any assistance/feedback would be appreciated.
02-25-2020 10:11 AM
- Cold boot the AP ; logon to it and issue show logging , check for errors.
M.
02-25-2020 12:55 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: