07-20-2013 09:35 AM - edited 07-04-2021 12:28 AM
Anyone ever seen this problem?
not working 3600e(config-if)#power local ?
<2 - 2> One of: 2
maximum Set power to allowed maximum
Instead of
working 3600e(config-if)#power local ?
<2 - 23> One of: 23 20 17 14 11 8 5 2
maximum Set power to allowed maximum
CCNP - Wireless
CWNA and CWAP
07-20-2013 09:51 AM
Have you tried to set the antenna gain first then see if the allowed power is available.
Sent from Cisco Technical Support iPhone App
07-20-2013 09:59 AM
yeah, I have also defaulted the AP. no luck. Power on the switch port shows 15.4 also
CCNP - Wireless
CWNA and CWAP
07-20-2013 10:07 AM
From show controller d1
Configured TxPower: -4 dBm
Allowed Power Levels: -4 dBm
Allowed Client Power Levels: -4 dBm
Active Rates:
CCNP - Wireless
CWNA and CWAP
07-20-2013 10:16 AM
What does this show when you issue the command:
show controllers dot11radio 0
show controllers dot11radio 1
Never mind... Didn't see your other post
Sent from Cisco Technical Support iPhone App
07-20-2013 10:18 AM
You see this on d0 also, -4 just means 40 MHz.
Sent from Cisco Technical Support iPhone App
07-20-2013 10:46 AM
I openned a tac case. The eng is saying "that's odd".... never a good sign.
CCNP - Wireless
CWNA and CWAP
07-20-2013 12:20 PM
http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCuf61780
CCNP - Wireless
CWNA and CWAP
07-20-2013 08:46 PM
What is the code running on the AP?
Sent from Cisco Technical Support iPhone App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: