Hello. I have cisco 3850 switch, which was configured as wireless controler. I have 2 APs AIR-CAP2702E-R-K9. Both APs were connected to Gi 1/0/13-14. I see mac address of this APs on both cisco ports, but when i use command sh ap summary i get this output:
Number of APs: 0
Global AP User Name: Not configured
Global AP Dot1x User Name: Not configured
Software on the switch
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 32 WS-C3850R-24T 03.06.06E cat3k_caa-universalk9 INSTALL
Switch short configuration bellow:
!
interface Vlan201
ip address 192.168.201.204 255.255.255.0
!
wireless mobility controller
wireless management interface Vlan201
ap country RU
ap group default-group
end
Licenses
Slot# License name Type Count Period left
----------------------------------------------------------
1 ipbase permanent N/A Lifetime
1 apcount adder 25 Lifetime
Gi1/0/13-14 mac address table
Vlan Mac Address Type Ports
---- ----------- -------- -----
201 3890.a5f9.37c8 DYNAMIC Gi1/0/14
Vlan Mac Address Type Ports
---- ----------- -------- -----
201 3890.a5f4.eb3c DYNAMIC Gi1/0/13
My question is: Why system didn't defined this APs as AP and didn't apply configuration from Cisco 3850 WC?