cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

6901
Views
0
Helpful
1
Replies
Beginner

CISCO AIR-LAP1252AG-A-K9 Autonomous DHCP config?

N00b questions:

  1. Can the 1252AG provide server DHCP in the Autonomous IOS configuration ? ( The WAP is connected to a Linksys router that is providing a NAT address via DHCP to the ethernet interface)
  2. What is the most basic DHCP configuration option ?
  3. I'm assuming the WAP can also pass through the NAT / DHCP from the Linksys router ? What would be the most basic configuration for that?

Thanks,

-Nick

1 REPLY 1
Beginner

Re: CISCO AIR-LAP1252AG-A-K9 Autonomous DHCP config?

https://supportforums.cisco.com/thread/2001254?tstart=0

http://www.cisco.com/en/US/docs/wireless/access_point/12.2_13_JA/configuration/guide/s13adm_ps4570_TSD_Products_Configuration_Guide_Chapter.html#wp1057097

"Configuring the Access Point to Provide DHCP Service

These sections describe how to configure the access point to act as a DHCP server:

•Setting up the DHCP Server

•Monitoring and Maintaining the DHCP Server Access Point
Setting up the DHCP Server

By default, access points are configured to receive IP settings from a DHCP server on your network. You can also configure an access point to act as a DHCP server to assign IP settings to devices on both your wired and wireless LANs."

I'm assuming this also applies to the 1252?

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards