07-11-2016 08:12 AM - edited 07-05-2021 05:24 AM
Hi Folks,
I'm having troubles with a wireless installation root / non root Bridge using autonomous AP.
The issue is that as soon as I enable encryption the connection is gone.
Without encryption everything is working fine.
I've attached the configs - may someone please check if I'm missing anything out?
Regards,
Christian
07-11-2016 12:34 PM
Noticed, non-root bridge radio1 is shutdown. Did you try to enable it manually ?
HTH
Rasika
07-12-2016 05:23 AM
Customer did what I told him to do -> to put the two APs more apart then 10 cms (0,328 feet).
Now Setup is working.
Keyword: Fresnel Zone
I was sure the config was correct as I did not found any mistake in it (Setup was working in my lab too).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: