cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
573
Views
0
Helpful
2
Replies
Highlighted

Cisco AP as Bridge Root / non-Root bridge | Configuration Improvements

Hi Folks,

I'm having troubles with a wireless installation root / non root Bridge using autonomous AP.

The issue is that as soon as I enable encryption the connection is gone.

Without encryption everything is working fine.

I've attached the configs - may someone please check if I'm missing anything out?

Regards,

Christian

2 REPLIES 2
Highlighted
VIP Mentor

Noticed, non-root bridge radio1 is shutdown. Did you try to enable it manually ?

HTH

Rasika

Highlighted

Customer did what I told him to do -> to put the two APs more apart then 10 cms (0,328 feet).

Now Setup is working.

Keyword: Fresnel Zone

I was sure the config was correct as I did not found any mistake in it (Setup was working in my lab too).

Content for Community-Ad