07-11-2016 08:12 AM - edited 07-05-2021 05:24 AM
Hi Folks,
I'm having troubles with a wireless installation root / non root Bridge using autonomous AP.
The issue is that as soon as I enable encryption the connection is gone.
Without encryption everything is working fine.
I've attached the configs - may someone please check if I'm missing anything out?
Regards,
Christian
07-11-2016 12:34 PM
Noticed, non-root bridge radio1 is shutdown. Did you try to enable it manually ?
HTH
Rasika
07-12-2016 05:23 AM
Customer did what I told him to do -> to put the two APs more apart then 10 cms (0,328 feet).
Now Setup is working.
Keyword: Fresnel Zone
I was sure the config was correct as I did not found any mistake in it (Setup was working in my lab too).
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide