Cisco Flex 7500 and anchor

[lmediavilla]

Hello, I couldn't find this on the Cisco Flex 7500 specs

http://www.cisco.com/en/US/partner/prod/collateral/wireless/ps6302/ps8322/ps11635/data_sheet_c78-650053.html

Do anybody know if I can set up an anchor mobility group between the Flex 7500 and the WLC 5508?

Kind regards

[Saravanan Lakshmanan · Accepted solution]

Yes, 5508 can be used as anchor controller for static anchoring while 7500 as foreign using central swtiching.

For Mobility:

Fault Tolerance

It is recommended to use Flex 7500 as both the primary and backup controllers.

Flex 7500 primary and backup controllers must be in the same mobility domain.

Ref:

http://www.cisco.com/en/US/products/ps11635/products_tech_note09186a0080b7f141.shtml

[lmediavilla]

Thank you very much Saravanan