Cisco IW3702 autonomous configuration

[jagalgon]

Dear All,

I have bought a IW3702 Cisco AP and I want to configure an autonomous IOS, for this I have downloaded the file ap3g2-k9w7-tar.153-3.JI3.tar from the URL "https://software.cisco.com/download/home/286287624/type/284180979/release/15.3.3-JI3?catid=278875243"

The problem is that I don't know the steps to install this software in my AP. Are there some instructions that I could do? I don't find any manual to follow

Best regards.

[Flavio Miranda]

Hi,

 You need a console cable, a patch-cord and a notebook. Then, console into the AP and follow this command:

#debug capwap console cli 

#conf t
#int g0
#ip address 192.168.1.1 255.255.255.0
#no sh

ping 192.168.1.2 (Use this IP on your notebook)

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.10.10.1, timeout is 2 seconds: !!!!!

Use this command to download the IOS into the AP:

#archive download-sw /force-reload /overwrite tftp://192.168.1.2/ap3g2-k9w7-tar.153-3.JI3.tar

-If I helped you somehow, please, rate it as useful.-

[jagalgon]

Hi,

I have done this options using tftpd64 as tftp server but I obtain the next error when I execute the command archive download-sw. These are the command that I I try execute:

$ enable

       password: Cisco

#debug capwap console cli

#conf t

#no sh

#show ip interface brief           -> I have the IP 192.168.1.40

#ping 192.168.1.35                -> I can do ping to the host 192.168.1.35

#archive download-sw /force-reload /overwrite tftp://192.168.1.35/ap3g2-k9w7-tar.153-3.JD4.tar

% Invalid input detected at '^' marker.

My AP don't know the command "archive download". Could be that Cisco AP 3702-4E don't have this command?

Thanks for your help!!

[Haydn Andrews]

You can follow my guide at my blog steps down to AP configuration:

https://thewlan.com.au/2016/09/27/configuring-a-cisco-ap-for-site-survey/