Cisco Mobility Express 8.10.130 and CWA with ISE Guest Portal
Hello all, I need some advise.
I am trying to set up a Guest WLAN on Mobility Express with the ability to authorize guests through a ISE Guest Portal(Sponsored or any other kind). I have ME 8.5.151 and i purposely upgrade it to 8.10.130. But in this version i does not see ability to attach url_redirect ACL/pre-auth acl to WLAN. I created redirect ACL under advanced security setting, but i does not see how to map it to WLAN
WLAN Security Settings(will see that no options for redirect acl and preauth acl):
but in ME version 8.8.100 i see these options (automatic generated redirect ACL and ability to create preauth-acl).
Can I setup Guest WLAN with ISE Guest Portal in this version(8.10.130), or should I upgrade/downgrade to some other verison?
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 22.214.171.124, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...