06-17-2019 11:44 PM - edited 07-05-2021 10:34 AM
I've downloaded and installed Cisco Mobility Express Software in Cisco Access Point 3820i. But after reboot, it doesn't broadcast SSID.
I've gone thru CLI configuration and configured the whole Controller but still it doesn't broadcast the SSID. I've factory reset the device. And still nothing.
Any advise would be much much appreciated.
Thanks
06-18-2019 12:34 AM
paste the sh version command output from AP console.
Regards
Dont forget to rate helpful posts
06-18-2019 07:22 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: