cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

840
Views
0
Helpful
2
Replies

Cisco Mobility Express Controller issue

I've downloaded and installed Cisco Mobility Express Software in Cisco Access Point 3820i. But after reboot, it doesn't broadcast SSID. 

 

I've gone thru CLI configuration and configured the whole Controller but still it doesn't broadcast the SSID. I've factory reset the device. And still nothing. 

 

Any advise would be much much appreciated. 

 

Thanks

2 REPLIES 2
VIP Mentor

Re: Cisco Mobility Express Controller issue

paste the sh version command output from AP console.

 

Regards

Dont forget to rate helpful posts

VIP Advocate

Re: Cisco Mobility Express Controller issue

The AP might not have enough power. Do you use a PoE+ power injector / switch?
The 2800 and 3800 require PoE+ to fully work. It works with PoE, but doesn't bring the radio interfaces up.
CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards