Cisco wlc 2504 ha sku configuration license question

[Demandonio]

Hi all,

I have to configure a Cisco wlc 2504-HA-k9 for high availability.

I configured everything:

I copied the configuration file from the primary wlc and configured it on the secondary.

I added the secondary wlc on every access point into the primary controller.

I added the secondary wlc on the Wireless - Global configuration - IP of the primary backup wlc

I issued the command config redundancy unit secondary on the second wlc, then if I issue "show redundancy summary" it says me its a secondary unit.

I guess I did everything but I have an important question about licenses:

The second wlc says I have 75 evaluation licenses and "NA" permanent licenses. Shouldnt it show me 75 permanent licenses?

If I digit "show license summary", I get this:

show license summary

License Store: Primary License Storage
StoreIndex: 0 Feature: base Version: 1.0
License Type: Permanent
License State: Active, Not in Use
License Count: Non-Counted
License Priority: Medium
License Store: Evaluation License Storage
StoreIndex: 1 Feature: base-ap-count Version: 1.0
License Type: Evaluation
License State: EULA Not Accepted
Evaluation total period: 12 weeks 6 days
Evaluation period left: 12 weeks 6 days
License Count: 75 / 0 (Active/In-use)
License Priority: None

Putting also the screen of the GUI scenario.

Also, if I try to modify licenses, it tells me I cant modify licenses on secondary HA-SKU controller, so it seems it's working correctly.

Can you give me some advices?

Thank you!

[Sandeep Choudhary]

you did it correctly. 

here i smy post abot N+1 HA 2504 WLC:

https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/

Regards

Dont forget to rate helpful posts

[Scott Fella]

I don't think that the 2504 supports SSO, only N+1. The 5508, you were able to have the 75 ap license to make is part of SSO.

[Demandonio · Accepted solution]

Okay, I tested it and it works perfectly :)

Thank you!