Cisco WLC 3504 - no more SSH/WebGUI (https) access after upgrade from 18.104.22.168 to 22.214.171.124
I have just run into an issue when upgrading our SSO-HA WLC-Cluster (3504) from SW release 126.96.36.199 to 188.8.131.52.
The upgrade itself worked well and afterwards the HA reduandancy had been restored and Console access was possible.
But for an unknown reason it was no longer possible to log on to the WLC via SSH or to the WebGUI via https.
When checking the running-config (show run-config) I saw that the Secure Web Mode had been disabled
Secure Web Mode............................. Disable
But even reenabling Secure WebMode didn't help.
The workaround that did the trick was failing over to the standby WLC as active by rebooting the primary active wlc and even after failing back to the former active SSH and HTTPS access had been restored.
Just to share this with you - perhaps you have run into a similar issue while upgrading your WLC to 184.108.40.206.
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...
Hello i have acces point 1815i cisco and we want installed in entreprise and we have camera surveillance wireless cisco so i want to know how much distance between ap 1815i and camera surveillance wi...
We want to broadcast a SSID (and allow users to connect) between certain times each day, and then take it offline. Unfortunately we dont have prime and only DNA Essential Smart licencing. All documents that I am seeing is that its possible if you have pri...
Hi all,I am looking for some guidance here, and I am quite certain that some of you, great minds, will be able to stir me in the right direction here. And a big thanks in advance. Here we go, i have three sites connected over private link MPLS....
Hi to all I purchase new AP C9120AXE converted to EWC.I notice when AP is booting a message related to default route not set that it says that can affect performance.Message is : %Default route without gateway, if not a point-to-point interface,...