09-10-2020 02:06 AM - edited 07-05-2021 12:29 PM
Where to find the location of config and boot file of Cisco WLC? The location I mean directory location.
09-10-2020 03:57 AM
Dont know about any directory but Controllers contain two kinds of memory: volatile RAM and NVRAM. At any time, you can save the configuration changes from active volatile RAM to non-volatile RAM (NVRAM) using one of these commands:
save config—Saves the configuration from volatile RAM to NVRAM without resetting the controller.
Regards
Dont forget to rate helpful posts
09-10-2020 06:11 AM
Hi Bhaskar,
test system dir <path> command may help. Have a look below thread
Rasika
*** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide