10-15-2015 01:30 AM - edited 07-05-2021 04:05 AM
If you issue the show port summary command on a Cisco Wireless Lan Controller
show port sum
STP Admin Physical Physical Link Link
Pr Type Stat Mode Mode Status Status Trap POE
-- ------- ---- ------- ---------- ---------- ------ ------- ---------
1 Normal Disa Enable Auto Auto Down Enable N/A
2 Normal Disa Enable Auto Auto Down Enable N/A
is this output applicable to the Management interface or the network interfaces of the device? cant quite figure it out and cannot get this interface to come up
thank you
10-15-2015 04:05 AM
Management interface is a logical interface (think VLAN). Ports are physical interface. Notice the Link Status shows "DOWN".
10-16-2015 04:11 PM
What WLC model is this ? 44xx ?
Make sure you connect these port to 1Gbps switchports
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: