command of controlleur

[Dhikra Marghli]

Hello

what are command that allow to configure 

 AP Country code.
AP Regulatory Domain............................. Unconfigured 

in moblity express 1815i !!???????,    that allow AP joind to controlleur 

Cisco Controller) >show ap config 802.11a AP28AC.9E89.48E0AP28AC.9E89.3DB8

Cisco AP Identifier.............................. 5
Cisco AP Name.................................... AP28AC.9E89.3DB8
Country code..................................... US - United States
Regulatory Domain allowed by Country............. 802.11bg:-A 802.11a:-AB
AP Country code.................................. -
AP Regulatory Domain............................. Unconfigured
Switch Port Number .............................. 1
MAC Address...................................... 28:ac:9e:89:3d:b8
IP Address Configuration......................... DHCP
IP Address....................................... Disabled
Telnet State..................................... Globally Disabled
Ssh State........................................ Globally Disabled
Virtual IP Address............................... Not Configured
Cisco AP Location................................ default location
Cisco AP Floor Label............................. 0
Cisco AP Group Name.............................. default-group
Primary Cisco Switch Name........................
Primary Cisco Switch IP Address.................. Not Configured
Secondary Cisco Switch Name......................
Secondary Cisco Switch IP Address................ Not Configured
Tertiary Cisco Switch Name.......................

[srkala]

From the WLC CLI,

(Cisco Controller) >config ap country US ?

<Cisco AP>     Enter the name of the Cisco AP.
all            Configure all the Cisco APs.

(Cisco Controller) >

[Dhikra Marghli]

For  AP Regulatory Domain............................. Unconfigured 

how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????

thanks in advance  

[Dhikra Marghli]

For  AP Regulatory Domain............................. Unconfigured 

how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????

thanks in advance  

[Leo Laohoo]

---

@Dhikra Marghli wrote:

how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????

Please read THIS.

[Dhikra Marghli]

Spoiler

or  AP Regulatory Domain............................. Unconfigured 

how i can configured Regulatory Domain  in acces point 1815 !!

thanks in advance 

[Leo Laohoo]

---

@Dhikra Marghli wrote:

how i can configured Regulatory Domain  in acces point 1815 !!

Please read > THIS <.

[Dhikra Marghli]

 THIS for  : AP Country code 

From the WLC CLI,

(Cisco Controller) >config ap country US ?

<Cisco AP>     Enter the name of the Cisco AP.
all            Configure all the Cisco APs.

(Cisco Controller) >

//////////////////////////////////////////////

But Also i would other command for : AP Regulatory Domain !!

if i configured code country  in acce point then i would tho know if  AP Regulatory Domain  is show automatic  !!!!!!!!!

[Leo Laohoo · Accepted solution]

AP Regulatory Domain cannot be changed.
If the AP has the wrong Regulatory Domain, contact the vendor and ask for the AP to be swapped out with the correct Regulatory Domain.

[Sandeep Choudhary · Accepted solution]

Configiure the country code as LEO mentioned. With country code AP will not join to it!

Regards

Dont forget to arte helpful posts