02-08-2019 11:25 AM - edited 07-05-2021 09:49 AM
Hello
what are command that allow to configure
AP Country code.
AP Regulatory Domain............................. Unconfigured
in moblity express 1815i !!???????, that allow AP joind to controlleur
Cisco Controller) >show ap config 802.11a AP28AC.9E89.48E0AP28AC.9E89.3DB8
Cisco AP Identifier.............................. 5
Cisco AP Name.................................... AP28AC.9E89.3DB8
Country code..................................... US - United States
Regulatory Domain allowed by Country............. 802.11bg:-A 802.11a:-AB
AP Country code.................................. -
AP Regulatory Domain............................. Unconfigured
Switch Port Number .............................. 1
MAC Address...................................... 28:ac:9e:89:3d:b8
IP Address Configuration......................... DHCP
IP Address....................................... Disabled
Telnet State..................................... Globally Disabled
Ssh State........................................ Globally Disabled
Virtual IP Address............................... Not Configured
Cisco AP Location................................ default location
Cisco AP Floor Label............................. 0
Cisco AP Group Name.............................. default-group
Primary Cisco Switch Name........................
Primary Cisco Switch IP Address.................. Not Configured
Secondary Cisco Switch Name......................
Secondary Cisco Switch IP Address................ Not Configured
Tertiary Cisco Switch Name.......................
Solved! Go to Solution.
02-09-2019 01:29 AM
02-13-2019 02:08 AM
Configiure the country code as LEO mentioned. With country code AP will not join to it!
Regards
Dont forget to arte helpful posts
02-08-2019 12:28 PM
From the WLC CLI,
(Cisco Controller) >config ap country US ?
<Cisco AP> Enter the name of the Cisco AP.
all Configure all the Cisco APs.
(Cisco Controller) >
02-08-2019 08:02 PM
For AP Regulatory Domain............................. Unconfigured
how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????
thanks in advance
02-08-2019 11:16 PM
For AP Regulatory Domain............................. Unconfigured
how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????
thanks in advance
02-09-2019 12:19 AM - edited 02-09-2019 12:20 AM
@Dhikra Marghli wrote:
how i can configured ????????? that allow AP joind to conrolleur molity express 1815i !!!???????
Please read THIS.
02-09-2019 12:26 AM
or AP Regulatory Domain............................. Unconfigured
how i can configured Regulatory Domain in acces point 1815 !!
thanks in advance
02-09-2019 12:58 AM
@Dhikra Marghli wrote:
how i can configured Regulatory Domain in acces point 1815 !!
Please read > THIS <.
02-09-2019 01:08 AM
THIS for : AP Country code
From the WLC CLI,
(Cisco Controller) >config ap country US ?
<Cisco AP> Enter the name of the Cisco AP.
all Configure all the Cisco APs.
(Cisco Controller) >
//////////////////////////////////////////////
But Also i would other command for : AP Regulatory Domain !!
if i configured code country in acce point then i would tho know if AP Regulatory Domain is show automatic !!!!!!!!!
02-09-2019 01:29 AM
02-13-2019 02:08 AM
Configiure the country code as LEO mentioned. With country code AP will not join to it!
Regards
Dont forget to arte helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: