cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
614
Views
0
Helpful
5
Replies

Computer connects to an AP that is farthest

        In my Job, some computers is connecting to AP that is farthest, But there are two APS closer and the signal gets too low, the computer only connects to the closest AP if I disconnect and reconnect

I have 2 controllers series 2500

model AIR-CT2504-K9

version 7.0.116.0

APs AIR-LAP1142N-T-K9

can anyone help me with this issue?

2 Accepted Solutions

Accepted Solutions

Leo Laohoo
Hall of Fame
Hall of Fame

The decision to which AP to connect to is done by the computer's wireless NIC.

Upgrade the firmware of the wireless NIC is your first step.

What are your wireless NIC's model?

View solution in original post

Upgrade the NIC drivers.

Have you read this?

View solution in original post

5 Replies 5

Leo Laohoo
Hall of Fame
Hall of Fame

The decision to which AP to connect to is done by the computer's wireless NIC.

Upgrade the firmware of the wireless NIC is your first step.

What are your wireless NIC's model?

hello,

my nic's model is  Realtek RTL8192CE Wireless LAN 802.11n PCI-E NIC

Upgrade the NIC drivers.

Have you read this?

Leo is right:) upgrade the driver and test again.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Thanks, I Updated the nic drivers and it's working now  properly

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: