cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

232
Views
0
Helpful
2
Replies
Beginner

Configuring APs

Hello All,

I'm in the process of configuring an AP to work without a controller, but I don't know from where to start or how to configure. Are all APs configurable via CLI? If not, which are ..

Also, I will install another AP later on, and want users to seamlessly move through the site without disconnecting .. Is that possible?

Best Regards,

Islam M. Nadim

Everyone's tags (1)
2 REPLIES 2
Engager

Re: Configuring APs

Hello, Wrong Forum - There are more chances of getting a better response in the Wireless section. Please move to Wireless Mobility, right hand side of your post you should be able to move.

P.S. look at FAT / autonomous AP

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_10b_JA/configuration/guide/scg12410b.html

HTH

Please rate useful posts & remember to mark any solved questions as answered. Thank you.

Please rate useful posts & remember to mark any solved questions as answered. Thank you.
Highlighted
Hall of Fame Master

Re: Configuring APs

There are many docs that can help you configure an autonomous AP. You just need to search on, How to configure access point. Seamless roaming is tricker on autonomous than lightweight. You would have to be able to use the authentication and be able to setup WDS. Here is a link for that.

http://www.cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43roamg.html

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards