Configuring both the radios on Autonomous APs with Radio role as "Work Group Bridge"

[Muhammed Adnan]

Hello Experts, 

Is there a way out to configure both the Radio's role to "Work Group Bridge"? When I attempt to move the 2nd radio's role too to WGB, I could not succeed. 

[Scott Fella]

Only one is supported for WGB.

[Muhammed Adnan]

Thanks Scott.

If we could use only one of the two radio interfaces on the Autonomous Access Point as the WGB client, can we use the second radio interface on the same Autonomous Access Point as Wireless client. 

I could find any documentation though to facilitate this?