Configuring Country code for 3702 AP

[sundarthavamani]

Hi,

I am unable to config the country code for 3702 AP. Pls any help me

[Sandeep Choudhary]

You don't need to configure country code Access Point!!! Normally its hard-coded in firmware.

Are you using AP with WLC or its a autonomous AP ?

Please paste the sh version output from AP.

Example:  AIR-CAP3702I-x-K9, Here X is the country/Region code(Ex: E is for Europe..., A for America)

Regards

Don't forget to rate helpful posts

[Prakash Parvathala]

HI

Controllers and access points are designed for use in many countries with varying regulatory requirements. The radios within the access points are assigned to a specific regulatory domain at the factory (such as -E for Europe), but the country code enables you to specify a particular country of operation (such as FR for France or ES for Spain). Configuring a country code ensures that each radio’s broadcast frequency bands, interfaces, channels, and transmit power levels are compliant with country-specific regulations.

[mohanak]

If it is an universal access point like below, then do priming

AIR-AP3702E-UXK9

AIR-AP3702I-UXK9

Refer link : http://www.cisco.com/c/en/us/td/docs/wireless/access_point/ux-ap/guide/uxap-mobapp-g.html