Connecting to Aironet 1702i AP

[Dmitry Golovenkin]

Picked up a new wireless AP today on NFR to play around with. It's a Cisco 1702i AP in a lightweight mode. I am trying to login to the AP to convert it to autonomous mode but to no avail.

I have tried using a console cable and get nothing (no login screen) and with SSH it does not accept Cisco/Cisco. I've tried resetting it to factory defaults by holding down the mode button while plugging in the power but still nothing...

The console cable works fine on other cisco devices like my ASA and 887 router.

Any ideas?

[Prakash Parvathala]

HI

check this links below which can help you on convert the AP.

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

https://supportforums.cisco.com/document/58026/lwapp-mode-autonomous-mode-conversion

https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points

[mohanak]

Refer link : https://learningnetwork.cisco.com/thread/14405

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

Also verify the led status of access point it will clear in which state access point is : http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1700/quick/guide/ap1700getstart.html