04-10-2013 04:14 PM - edited 07-03-2021 11:53 PM
Not sure if it's new in WLC 7.4 code, but I now see "Dual-band radio" section everywhere in addition to "802.11a/n" and "802.11b/g/n". My dual band APs (for example 2600's) show up under both 802.11a/n and 802.11b/g/n as in the past. So what is this new category "dual-band radio" for then?
04-10-2013 04:37 PM
That category is the for 802.11ac optional module for the AP3600.
04-10-2013 06:07 PM
It's for any of the 3 modules for the 3602's.
Sent from Cisco Technical Support iPhone App
04-10-2013 06:22 PM
These are the 3 modules that will show up as the dual-band radios
Module Options
Wireless Security and Spectrum Intelligence module
• Provides full-spectrum, off-channel scanning for comprehensive wIPS, including Cisco CleanAir technology, rogue detection, context awareness, and radio resource management (RRM) solutions. Scans 2.4- and 5-GHz channels while serving data clients on the base dual-band access point platform
IEEE 802.11ac Wave 1 module (Available Q2CY13)
• Supports 3x3:3SS (spatial streams), 80-MHz wide channels, 256 quadrature amplitude modulation (QAM), and data rates up to 1.3 Gbps (as part of IEEE 802.11ac Wave 1)
• Wi-Fi Alliance certification expected in Q2 2013
Cisco 3G Small Cell Module (Available 2HCY13)
• 3GPP Band 1 (2100 MHz), 16 users, Voice (R99), Packet Data (HSPA/HSDPA+)
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide