EDRRM AQ and AQI

[sreejith_r]

Hi ;

     Whats the difference between EDRRM AQ and AQI. If we are setting the  sensitivity on the EDRRM to high the value will be 60. Whats the value we are configuring the AQI in the clear air tab. is it only for traps.

If i want to change the AP  channel  based on the AQI value where i should set . 

I should change the EDRRM to high or change the AQI value in the clean air.

Thanks & Regards

Sreejith R

[Rasika Nayanajith]

Hi Sreejith,

Here is some reference post on this topic

http://mrncciew.com/2013/05/02/event-driven-rrm/

If you change the sensitivity to "high", then it is good idea to change AQI alarm threshold to 60 as well. Yes AQI threshold is only for traps.

You need to enable Clean Air & change EDRRM sensitivity (High-60, Medium-50, Low-35) in order to change  AP channel based on AQI value of 60,50 or 35

HTH

Rasika

**** Pls rate all useful responses ****

[sreejith_r]

Thanks Rasika

So it means if we want to trigger the channel change based on AQI , its not necessary to change the AQI threshold

Only change the EDRRM to low/medium/high and enable clean air.

Please confirm

[Rasika Nayanajith · Accepted solution]

Hi Sreejith,

Yes, that should be fine.

Pls mark this thread "answered" if this clarify your query.

HTH

Rasika