cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

146
Views
10
Helpful
7
Replies
Highlighted
Beginner

Error in setting community status during configuration in PI.

Hello all,

I've monitored using PI my APs...

During monitoring, I clicked Apply at SNMP tap.

But upper log came out..

In this case, what should I do ?..

That issue came out before 1 week...

Regards,

SK.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Master

Okay.. well I would try just

Okay.. well I would try just setting one and see if the error goes away. If so, then at least you know you are hitting a bug:)

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***
7 REPLIES 7
Hall of Fame Master

If your not using v3 then

If your not using v3 then disable that and just try v2. If your using v3 then disable v2.  I would setup v2 first.

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***
Beginner

Thank you Scott.

Thank you Scott.

What do you mean V2 and V3..?

SK

Hall of Fame Master

I'm looking at the screen

I'm looking at the screen shot you attached. It's complaining about snmp community strings. 

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***
Beginner

Ah!

Ah!

My superior staff want to use V2 and V3 both...!

Hall of Fame Master

Okay.. well I would try just

Okay.. well I would try just setting one and see if the error goes away. If so, then at least you know you are hitting a bug:)

-Scott 

*** Please rate helpful posts *** 

-Scott
*** Please rate helpful posts ***
VIP Mentor

Are these WLC managed APs or

Are these WLC managed APs or standalone APs ?

Rasika

Beginner

AP image type : MOBILITY

AP image type : MOBILITY EXPRESS IMAGE..

Actually I don't know whether standalone or not .

How can I verify that?

SK

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards