Error message in cisco 1242AG AP

[newtamil2011]

Hi Experts,

One of our AP 1242AG autonomous model giving the error continiously "MDIO_wait: PHY error. port 0" . Hence we have done the reset , formatted the flash , downgraded the image to c1240-k9w7-tar.124-10b.JDA3.tar .

But still we are getting the same message.Whereas Fastethernet port 0 connectivity is fine without any issue . Any idea on this.

Thanks ,

Tamil

[Sandeep Choudhary]

Hi Tamil,

Can you paste the complete logs from AP(Console access).

Regards

Dont forget to rate helpful posts

[newtamil2011]

Hi Sandeep,

PFA of logs.

Thanks

[Sandeep Choudhary]

Raise a TAC case and clarify with them.(You will need a valid CCO contract to raise a case)

http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html

Regards

Dont forget to rate helpful posts