11-24-2016 09:04 AM - edited 07-05-2021 06:09 AM
Hello All,
When setting DCA interval to 8 hours, it shows the below error.
"DCA channel interval cannot be set"
Any guess. Thanks in advance
Solved! Go to Solution.
11-24-2016 11:58 AM
If you are running v8.2MR1, there is a new feature called Flexible Radio Assignment. You might be running into this as it is set to 1 hour. You need to set the FRA to an equal of higher value:
config advanced fra interval 24
config advanced 802.11a channel dca interval 24
save config
y
Hope this helps
-Scott
*** Please rate helpful posts ***
11-24-2016 10:37 AM
Did you disable your radios (2.4 & 5 GHz) on your WLC first ? If not try that
HTH
Rasika
11-24-2016 11:05 AM
Yes.. we did.. it allows to set 1hour but throwing error for rest..
11-24-2016 11:58 AM
If you are running v8.2MR1, there is a new feature called Flexible Radio Assignment. You might be running into this as it is set to 1 hour. You need to set the FRA to an equal of higher value:
config advanced fra interval 24
config advanced 802.11a channel dca interval 24
save config
y
Hope this helps
-Scott
*** Please rate helpful posts ***
11-25-2016 07:32 AM
Thanks scott.. it worked..
11-25-2016 08:19 AM
Glad that worked!
-Scott
02-15-2017 01:05 PM
Still applicable to 8.2.141.0
How stupid that is? My FRA is disable, but I still have to go into CLI to set it to 24H, without it GUI doesn't allow to change DCA. Cisco is soooo Cisco.
05-30-2017 10:26 AM
We have an enhancement request (CSCva05977) submitted to resolve this issue in 8.3 and 8.4 releases. As of today it looks like neither has received a commitment to the versions. Please encourage your Cisco contacts to push for these resolutions.
06-13-2017 02:03 PM
Thanks Chris
04-10-2018 04:23 AM
08-02-2017 09:56 AM
Excellent!!! thanks.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: