cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
119
Views
0
Helpful
1
Replies
Beginner

From the Vlan 44 interface I am not able to ping the Vlan 3 interface of the Core Switch.

Hi everybody;

 

I have the following scenario (IP's are fake, is only orientative example), i am implementing a new mobility express topology because in our company everybody is still using ethernet cable :S, the following topology is that:

 

    Laptop                  ------        WLC                           --------     Switch 1                      -------          CORE

 

Ip Address                                DHCP Pool                                     Int Vlan 44                                           int vlan 3

192.168.45.231                       192.168.44.0                                 192.168.44.2                                 192.168.3.1/24

255.255.254.0                         255.255.254.0                               255.255.254.0

GW                                           GW                                                Int vlan 3

192.168.44.2                           192.168.44.2                                 192.168.3.4/24

Vlan 44                                     Vlan 44                                          default router to:

                                                Management vlan 10                       192.168.3.1

                                                192.168.10.90/24

                                                 Default GW for vlan 10                 Management vlan 10

                                                 192.168.10.22/24                        192.168.10.22/24

                                                                                                      

 

From the test laptop i am able to ping his GW 192.168.44.2 and the IP 192.168.3.4 but i am not be able to ping the CORE Ip address 192.168.3.1.

 

From the Switch 1, obviously i can ping the IP 192.168.3.1 from the Core, and even i can ping 192.168.3.1 source 192.168.44.2

 

On Switch1 the use default ip route to the ip address 192.168.3.1 (interface vlan 3 of Core)

 

On Core i use this static route:

ip route 192.168.44.0 255.255.254.0 192.168.3.4

 

What's wrong? I forgot something? I only use in this case static routes.

1 REPLY 1
VIP Engager

Re: From the Vlan 44 interface I am not able to ping the Vlan 3 interface of the Core Switch.

On the core you also need the 'int vlan 44' with an IP address from the vlan 44. Otherwise it doesn't route the packets.
Unless your "switch 1" is also a router and has the routing process enabled.
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards