10-14-2014 07:39 PM - edited 07-05-2021 01:43 AM
Hi you all
I got two WLC2504 and I need them in HA(primary controller and secondary controller HA-SKU). I already set them up like this:
Primary controller
1)Dynamic, virtual and management interfaces
2)WLANs
3)AP Groups
4) Wireless>Access Points>Global Configuration>High Availability>Backup Primary controller IP and Backup Primary controller name
5) AP Fall Back
6) Mobility Groups
Secondary controller
1) HA SKU secondary unit
2) Mobility Groups
3) AP Fall Back
But what happens with dynamic interfaces, wlans, virtual interfaces, managament on primary controller? , These parameters should be the same on both wlc?. what do i have to do to get wlc2504 high availability done?.
Consider that both wlcs will be working through wan link, on different domain broadcast, or should it work on the same broadcast domain?
Any suggestions, documents, they'll be well received.
Thank you
10-16-2014 02:53 AM
You can try with this configuration ;
https://supportforums.cisco.com/discussion/12160596/how-can-i-configure-wlc-2504-do-ha-n1-method
05-22-2015 10:56 AM
Here you go for the best documents for HA configurations
https://supportforums.cisco.com/discussion/11874876/does-wlc-2504-supports-ha-or-not
05-26-2015 04:14 PM
Please refer to the below links:
https://supportforums.cisco.com/discussion/12442631/cisco-wlc-2504-ha-deployment-issue
and
https://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: