How do I add an AP license to a license that is used in the WLC 5520?

[Jason107]

嗨先生，

WLC 5520許可證上有62個AP，將來會添加10個AP。如何將10個AP許可證添加到現有許可證中。

管理>軟件激活>許可證

在Licese Count選項中，選擇添加並在值字段中輸入值10或72？

謝謝。

[luis_cordova]

Hi @Jason107 ,

Check this link:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-2/config-guide/b_cg82/b_cg82_chapter_0100.html#ID308

Viewing Licenses (GUI)

Procedure

---

Step 1

Choose Management > Software Activation > Licenses to open the Licenses page. This page lists all the licenses that are installed on the controller. For each license, it shows the license type, expiration, count (the maximum number of access points that are allowed for this license), priority (low, medium, or high), and status (in use, not in use, inactive, or EULA not accepted).

Therefore, I think you should place the APs allowed by the license you are installing.

Regards

[Daniel Ordóñez Flores]

Hi @Jason107 

Step 1: Choose Management > Software Activation > Licenses to open the Licenses page

Step 2: In the Adder License area, choose to add or delete the number of APs that an AP license can support, enter a value, and click Set Count.

Step 3: Save the configuration.

If you want to do it by CLI then issue this command:

license add ap-count <number of APs>
show license summary
save config

Espero que la información haya sido útil y si no tienes más preguntas recuerda cerrar el topic, seleccionando la respuesta como "Respuesta correcta"

**Please rate the answer if this information was useful***

**Por favor si la información fue util marca esta respuesta como correcta**

*Tu reconocimiento nos alienta a seguir participando en los foros *

[jagan.chowdam · Accepted solution]

You'll add 10 AP license. 5520 controllers support Right to Use (RTU) licensing model. 

** Please rate this response if helpful**

CJ

[Jason107]

Hi Sir,

62 APs on the WLC 5520 license, add 10 APs license, will the new license RTU count show 10 or 72 licenses?

[Daniel Ordóñez Flores]

Hi @Jason107 

It will be 72