07-23-2008 10:43 AM - edited 07-03-2021 04:13 PM
I can log onto my AP using the cisco and password. However, if I try to access network interfaces, I am prompted for a username and password again. Apparently the two are not the same. Is it better to reinitialize the unit and replace the configuration?
07-23-2008 12:49 PM
Hi Michael,
You are on the right track with resetting the unit to default and replacing the config;
Password Recovery Procedure for the Cisco Aironet Equipment
Hope this helps!
Ron
07-24-2008 05:14 AM
Thanks. this worked
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide