cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
900
Views
3
Helpful
3
Replies

How do you show WLCs configured on an LWAP?

thefranmanatt
Level 1
Level 1

How do you show the controllers configured on an AP?  When I read through the docs it say to use the show capwap ip config.

Verify

You can use the show capwap ip config command in enable mode to view the CAPWAP configuration present on the LAP.

Here is an example:

AP1240#show capwap ip config 

LWAPP Static IP Configuration
IP Address         10.77.244.199
IP netmask         255.255.255.224
Default Gateway    10.77.244.220
Primary Controller 172.16.1.50

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml

When I run it I get no output. I am guessing because the AP is DHCP

3602-E#sh capwap ip config

LWAPP Static IP Configuration

I am not having any luck finding this data anywhere else.

3602-E#more flash:private-config

%Error opening flash:private-config (Permission denied)

thanks

CCNP - Wireless
CWNA and CWAP       

CCNP - Wireless
CWNE #136
1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

you can try show capwap client config

you are looking for the "mwar" lines

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame

try: show capwap client rcb

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***

Stephen Rodriguez
Cisco Employee
Cisco Employee

you can try show capwap client config

you are looking for the "mwar" lines

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

show capwap client config  shows me all the controllers configured.  thanks!

CCNP - Wireless
CWNA and CWAP

CCNP - Wireless
CWNE #136
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: