02-11-2019 06:56 AM - edited 07-05-2021 09:49 AM
N(Cisco Controller) >show ap summary
Number of APs.................................... 2
Global AP User Name.............................. AP-TEST
Global AP Dot1x User Name........................ Not Configured
Global AP Dot1x EAP Method....................... EAP-FAST
* prefix indicates Cisco Internal AP
AP Name Slots AP Model Ethernet MAC Location Country IP Address Clients DSE
------------------------------ ----- -------------------- ----------------- -------------------- ---------- --------------- ------- ----
*AP780C.F0DB.2A90 2 AIR-AP1815I-I-K9 78:0c:f0:db:2a:90 default location TN 1.1.1.134 0 [0
AP28AC.9E89.48E0 2 AIR-AP1815I-I-K 28:ac:9e:89:48:e0 default location 1.1.1.25 0 [0
when i configured the AP28AC.9E89.48E0 with the same configuration code country TN as AP780C.F0DB.2A90 ,
teh AP don't accpted the code country and tell me AP name invalid :
config ap disable .......
config ap country TN ......
Other RQ: how i can allow AP28AC.9E89.48E0 is AIR-AP1815I-I-K 9 ?????????,
1) Why AP1 with AIR-AP1815I-I-K 9 and AP 2 AIR-AP1815I-I-K ?????, :
2) WHY AP2 don't accpet any country ?,, what i can do with AP2
3) AP1 version 8.8.100 and AP2 8.8.100
thanks in advance
02-12-2019 02:25 AM
02-12-2019 02:54 AM
Just i give you other information about controller and AP is as a controlleur 1815i
Cisco Controller) >
(Cisco Controller) >show tech-support
---------------Show boot---------------
Primary Boot Image............................... 8.8.100.0 (default) (active)
Backup Boot Image................................ 8.8.111.0
//////////////////////////////////////////////////////////////////////
AP as a Moblity express==========>
cisco AIR-AP1815I-I-K9 ARMv7 Processor rev 5 (v7l) with 1016100/429856K bytes of memory.
Processor board ID FGL2221B268
AP Running Image : 8.8.100.0
Primary Boot Image : 8.8.100.0
Backup Boot Image : 8.8.111.0
Primary Boot Image Hash: 667206093befba1a8a421436cc32e2097e0fb95f0a02ca18c06c762f2b85abab7fcd1a7161346951bcf1179903654d005aaf1a719bb21940bf70abf31e88228e
I put AP CAPWAP with 8.8.111 but it reload and Back to 8.8.100 !!because controlleur is boot with 8.8.100
SO what i can do the next !!
thanks
02-12-2019 03:04 AM
Use CLI:
config boot backup save config reset system force
NOTE: If you still can't get this ME to boot 8.8.111.0 then I strongly recommend you get or find someone who can.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide