How to check if WLC is configured for DHCP or not

[mahesh18]

                   Hi Everyone,

Is there any command CLI  that can tell me if users are getting IP from WLC  or not?

Regards

Mahesh

[Anas Naqvi · Accepted solution]

Hi Mahesh,

Try using  ‘show dhcp summary’

For more information check the below link,

http://www.cisco.com/en/US/docs/wireless/controller/7.0/configuration/guide/c70wlan.html

[mahesh18]

Hi Anas,

>show dhcp summary

No scopes defined

Does this mean that users are getting ip from the External dhcp device?

Regards

Mahesh

[Rasika Nayanajith · Accepted solution]

Hi Mahesh,

Yes, this mean you have not configured your WLC to act as a DHCP server with pre-defined pools.

If clients getting IP address they should get it from an external dhcp server.

If you check the interface configuration you should see a DHCP server IP address configured. In CLI if you type "show interface detailed " that also provide the configured DHCP server information

Here is an example of such CLI output

(4402-3) >show interface detailed vlan130

Interface Name................................... vlan130

MAC Address...................................... 00:0b:85:43:d8:67

IP Address....................................... 192.168.130.33

IP Netmask....................................... 255.255.255.0

IP Gateway....................................... 192.168.130.1

External NAT IP State............................ Disabled

External NAT IP Address.......................... 0.0.0.0

VLAN............................................. 130      

Quarantine-vlan.................................. 0

Active Physical Port............................. LAG (29)

Primary Physical Port............................ LAG (29)

Backup Physical Port............................. Unconfigured

Primary DHCP Server.............................. 192.168.130.1

Secondary DHCP Server............................ Unconfigured

DHCP Option 82................................... Disabled

ACL.............................................. Unconfigured

AP Manager....................................... No

Guest Interface.................................. No

L2 Multicast..................................... Enabled

HTH

Rasika

[mahesh18]

Hi Rasika,

Thanks for the reply.

Regards

Mahesh

[Rasika Nayanajith]

Thanks for rating useful responses...

[Abhishek Abhishek]

show capwap client ip config

To display the capwap static IP configuration, use the show capwap client ip config command.

show capwap client ip config

Syntax Description

This command has no arguments or keywords.

Defaults

None.

Examples

This example shows how to display the capwap static IP information:

> show capwap client config

LWAPP Static IP Configuration

Primary Controller 9.41.80.88    

[mahesh18]

Hi Abhishek,

Show capwap command is not available

>show c?

cac            call-control   cdp            certificate    client

coredump       country        cpu            custom-web

(Cisco Controller) >

Regards

Mahesh