how to check that antennas are connected to access point?

[Andrey128]

Which command(s) can show whether antennas are connected to access point and to which transmitter on access point (2.4 Ghz vs 5Ghz)?

If found that #show controllers d0 or d1 gives this output

....

Antenna: external, Gain: Allowed 4, Reported 4, In Use 4

.....

However the result looks not always correct. (sometimes controller without antenna showed the same as with antenna).

Please give advise(s).

[Leo Laohoo]

No command available.  The output of the "sh controllers" is statically assigned and can be changed manually.