cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
431
Views
0
Helpful
2
Replies
Highlighted
Beginner

How to configure 3 X 4410N to extend wifi ?

Hi everybody

I would like to configure 3 Access Point (WAP4410N) to extend the wifi in my house. I try it to do several configuration but it doesn't work.

In this configuration, the wifi devices disappears and re-appears constantly. I lose the IP addresses and they all come down only every 5 seconds.

I made screen shots of the 3 terminals in the word document attached below. Can you help me please

Thanks you

Stef

2 REPLIES 2
Highlighted
Cisco Employee

In order for an AP to work in repeater mode, there must be 50% overlap on the signal and the APs must be on the same channel. For each repeater that is setup the actual throughput is roughly half.

Highlighted

Ok So I changed the configuration about the wireless. I plugged every AP with wire and I have configured it as AP with the same SSID.

I think is the better configuration for actually.

Thanks

Content for Community-Ad