How to prevent clients from associating with 350 root bridge?
All our bridges and access points and clients use the same open authentication with static WEP key. Short of deploying a custom configuration for my bridge connections, is there a way to prevent clients other than bridges in client role from associating with my root bridge?
Re: How to prevent clients from associating with 350 root bridge
How about AP's with lower signal strength in the same vicinity as the root bridge... if a client finds two signals (a strong one from the bridge and a weaker one from a nearby access point) and gets rejected from associating with the "good" signal due to MAC address filtering, will the client still try to associate with the weaker signal afterwards? Thanks for the link to the document; very helpful.
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...