cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3494
Views
0
Helpful
7
Replies
Highlighted

joint AP to wireless controller 2504

hello all,

I am new in wireless , i have Cisco wireless controller 2504 for 50 access point,  access point 1262 and switch 3560.

i setup the controller correctly and i contect it to the switch and connect the AP to the switch.

i can ping from the AP to the controller and vis versa.

but the controller can not joint the AP.

please any help or idea.

best Regards

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Re: joint AP to wireless controller 2504

Make sure the time (NTP) is set correctly on the WLC. Also place the AP's on the same vlan (for now) as the WLC. Console into the AP and make sure the AP is getting an IP address. Also post the output for us to see.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

View solution in original post

7 REPLIES 7
Highlighted
Hall of Fame Master

Re: joint AP to wireless controller 2504

Make sure the time (NTP) is set correctly on the WLC. Also place the AP's on the same vlan (for now) as the WLC. Console into the AP and make sure the AP is getting an IP address. Also post the output for us to see.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

View solution in original post

Highlighted

joint AP to wireless controller 2504

thax for your replay

i puting all in native vlan 1

its trunk between WCL and switch & trunk between AP and switch.

BR

Highlighted
Hall of Fame Master

joint AP to wireless controller 2504

You don't need a trunk between the AP and the switch if the AP's are in local mode.  Only if the AP's are in H-Reap or FlexConnect do you have to configure the port as a trunk.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

-Scott
*** Please rate helpful posts ***
Highlighted

joint AP to wireless controller 2504

Dear scott

I modify in my topology so like below:

WLC connected to switch by Trunk linke,

AP connected to switch by access mode in deffirent vlan.

the IP address sechma :

1- WLC 192.168.10.1 , Gateway in switch         192.168.10.254 ( vlan 10 )

2- AP 10.10.10.2 ( DHCP ) , Gateway in switch 10.10.10.254     (vlan 20)

DHCP server its the switch is self , we enable option 43

Images

AP Image : C1260 Software (AP3G1-K9W7-M), Version 12.4(25d)JA1, RELEASE SOFTWARE (fc1)

WLC Image : Primary Boot Image............................... 7.2.103.0

But still AP can't join the WLC !!! i follow the steps in cisco doc's.

so please more help.

Thnx

Highlighted
Beginner

Re: joint AP to wireless controller 2504

Hi,

Firmware version of AP K9W7 is autonomous so autonomous ap never join WLC . First you need to change firmware autonomous to LAP which is k9w8 then AP registered with WLC.

Highlighted
Hall of Fame Master

Re: joint AP to wireless controller 2504

Here is a document you can reference.

http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Highlighted
Hall of Fame Master

Re: joint AP to wireless controller 2504

Better yet, a support doc.

https://supportforums.cisco.com/docs/DOC-17826

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
CreatePlease to create content
Content for Community-Ad